The 90 Degree feeding shrink wrap machine is more cost effective and less time consuming for packing of products but in comparison to space constrain it will take little bit more place.

In consideration to technical aspects a 90 Degree feeding shrink wrap machine consumes less power and less air pressure as there will less operating pneumatic cylinders

1. ●The products which are planning to shrink-wrap will travel in a single line 90 degree to pneumatic pusher which pushes the products onto sealing units (web sealer)
2. ●A pneumatic pusher collates the boxes / containers into the pre-selected pack formation, once the required gets formed the product holder holds the matrix and the sensor will give the signal to seal bar to cut and seal the paper.
3. ●Once the welding bar ascends, the pusher advances to transfer the new collation into the welding position, at the same time displacing the previously wrapped collation onto continuously moving wire mesh shrink tunnel conveyor.
4. ●The wrapped collation soon enters the shrink tunnel chamber where re-circulated hot air causes the wrap to shrink and tightly conform to the contours of the contents.
5. ●Once the pack is out of the hot chamber , forced air cooling is used to tighten sleeve wrap to achieve a strong, secure pack ready for stacking on pallet or a placing on a shipping carton.